[Solved] 2 addresses into the Android wallet, Is it possible ?
-
Hi to all
Few days ago I has successfully installed the wallet ver 2 into an Android device.
Syncs with the net Ok…
After the installation I just imported successfully a private key with 100 Ftc inside (no errors after the password…)
After imported the key, the wallet does not displayed the coins into the balance.
Power off and power on but nothing… no coins in balance.
At this point I have doubts about if the android wallet are be able or not to manage more than one address…
Note that after these test, i just imported the same private key into a wallet.dat into a PC with XP without no problem
Any Ideas ?
-
Hi Xonar,
I had a look in the code, and in principle the Android Wallet is designed to handle multiple addresses.
We will try to duplicate your problem and find the cause.
-
Ok thank you, it’s a very good support. I has only one android dev, and after re-install the wallet and try to import, the problem persist.
Thank you very much.
-
Hi Xonar,
we tried to duplicate your problem without success.
When we import a key on a mobile phone installation, the wallet re-syncs the whole blockchain and the associated balance is shown correctly.
Can you try to force a re-sync after you import a key?
It’s done under ‘settings’ in the Diagnostics area.
-
At the first, thank you for support. ^-^
Under “settings” into the “Diagnostics” i found “Report Issue” and “Reset Blockchain”
If the re-sync is “Reset Blockchain”, yes, I try it but nothing happen.
Anyway I’m going to reset completely the device and re-install the wallet.
The coins were saved…
^-^
