Is this method is acceptable for 'faulty' @ 'dead' gpu....? 'baking-gpu-in-oven'....!!
-
heyya peps…
as title above matters, below is d video dat shows d 'method…
.
https://m.youtube.com/watch?v=uu1s1EOPJlY
.
is this for real… or just a ‘troll’ or ‘parody’ thing…? :o0
.
.
*Hepi-FTC-mining… ;o) -
I wouldnt recommend to bake your gpu :D
- If there is “Dead gpu” just try to restart the core itself, not the whole miner.
There is an option on every miner to restart the single core, try it.
Regards,
ChekaZ -
It’s a last-ditch thing to try, but it can work if the problem is a bad solder joint.
Re-flowing lead-free solder would require closer to 200°C, so heating to 190-192°C is probably close enough so that the solder doesn’t actually melt and allow components to dislodge/fall out in the oven. You’ll most certainly reduce the life of any electrolytic capacitors by quite a bit, even if the card works again. Most electrolyte has a low boiling point; can be closer to water (100°C).
-
Ive tried this on 4 or so “dead” cards, only one came back to life. Its really a last option before tossing cards in the trash.
-
I have tried baking in oven on 4 dead cards, one is “fixed”, 2 came back temporarily.
I used an “oven thermometer”, to get “exactly” 280 Deg C.
-
Tried this in the past 0/2 cards came back to life but its worth a shot if your warranty is already void.
-
thanx for reply n sharing d experience, ‘fellow-seniors’…
At 1st, i thought it was some kind of ‘stupid-joke’…but its not actolly ehh… :o0
been ‘vouch’ then…-just experienced d ‘dead-gpu’ anyway…
1x r9 290 trix… :3)
.
.
.
1 FTC = 1 USD…fInGeR-Xross…1 FTC = 1 USD…fInGeR-Xross…1 FTC = 1 USD…fInGeR-Xross…1 FTC = 1 USD…fInGeR-Xross…1 FTC = 1 USD…fInGeR-Xross…
